K4 battery

dcadet

Hi, wondering if anyone has come across this before. My K4 battery is struggling to fire when connected to the tank. If I unscrew the tank the battery light comes on as normal but when I connect it the fire lasts a second or 2 then fades out to nothing. If I leave it half hour or so I get a few good fires then same again. Is this a common problem? Any solutions? Thanks in advance.

Cegoca · September 2016

Have you tried that same tank on another device yet ?

Tina · September 2016

@ dcadet If you want get your problem solved,here is are kind suggestion:
please take a short video to show your problem,and send it to our service: service@aspirecig.com
she will check with our engineer if this is normal or not.

Best Regards

dcadet · September 2016

Cegoca - thanks for the response. I haven't but I've tried different tanks on this device.

dcadet · September 2016

Tina - thanks for the advice. I will do that later today.

Cegoca · September 2016

dcadet said:
Cegoca - thanks for the response. I haven't but I've tried different tanks on this device.

And ? Could the other tanks be fired, because there is a big change they are not set up to be used with the K4 battery (resistance ...) ?

dcadet · September 2016

Same result. I've used my Arctic tank on this battery since I broke my glass about 2 months ago and it's worked fine until recently. I wondered if it was a bad batch of coils but I've tried a variety and no joy, as well as buying new tank to try.

dcadet · September 2016

Resistance is either .2 or .5 no difference in result

Cegoca · September 2016

The K4 is for 0.27 Ohm coils only.
This might be your problem.

dcadet · September 2016

Maybe I fried it running .2s on it but it was fine for a couple months. Cheers for the help.

Tina · September 2016

@dcadet Yes,the K4 battery is for 0.27ohm coils only.
Thank you @Cegoca for explanation ;;)

Cegoca · September 2016

@Tina ;)

Categories

In this Discussion

Top Posters

K4 battery